Reference: W.H_FW-09.01-L400
Bridge height: 70 mm Bridge width: 115 mm EPDM tape Aluminium
Reference: W.H_FW UCH-22
Material: stainless steel Thickness [mm] 4 Width [mm] 32 Length [mm] 82 Hole diameter [mm] 11 Additional information: Adjustment opening 40x11 mm.
Reference: M.H_NAKR KW M8
Technical data: diameter - M8 material - A2 stainless steel (1.4301) Standard - DIN 557
Banner
Polityka bezpieczeństwa
Zasady zwrotu
Mounting triangles/set square are used when mounting flat or low-slope roof constructions. Mounting triangles are left or right sided. Left sided triangle is used on the edge of the entire structure of our panels. This type is suitable for mounting panels in horizontal orientation.
Our triangles can be cut so that we can set a slightly different angle to the sun. However, most often most of the surface of the country is located at an angle of 15 degrees.
The triangles are made of aluminum on an L-type angle bracket base. The use of right and left sided triangles/Set square is very important, especially if you decide to go into the installation of a load construction. For this type of solution, L-type profiles are additionally used between the right and left sided triangles, which are then pressed with weights.
CONSTRUCTION:
INTENDED USE:
On flat or low-slope roof constructions (e.g. for a garage or halls).
Need a different type of triangles? Contact us!
Reference: M.H_SRUB MA M10X25
Diameter M10 Length: 25 mm Material: Stainless steel A2 (1.4301) Standard: DIN 933
Reference: W.H_FW-KDP-V15ST.01
Vertical aluminum mounting triangle with an angle of 15° for mounting solar panels on flat or low-slope roofs. Angle: 40x40 mm Angle thickness: 3 mm
Reference: M.H_NAKR KOŁN M10
Specifications: Flange diameter [mm] 21 Flange height [mm] 2 Serrated on the underside of the flange. Material: A2-70 stainless steel
Reference: W.H_FW-25.01-L300
Bridge length: 300 mm Bridge height: 100 mm Bridge width: 119 mm EPDM tape Aluminium
Reference: M.H_NAKR KW M8
Technical data: diameter - M8 material - A2 stainless steel (1.4301) Standard - DIN 557
Horizontal aluminum mounting triangle with an angle of 15° for mounting solar panels on flat or low-slope roofs.
