Reference: W.H_FW-09.01-L400
Bridge height: 70 mm Bridge width: 115 mm EPDM tape Aluminium
Reference: W.H_FW UCH-22
Material: stainless steel Thickness [mm] 4 Width [mm] 32 Length [mm] 82 Hole diameter [mm] 11 Additional information: Adjustment opening 40x11 mm.
Reference: M.H_NAKR KW M8
Technical data: diameter - M8 material - A2 stainless steel (1.4301) Standard - DIN 557
Banner
Polityka bezpieczeństwa
Zasady zwrotu
Mounting triangles/set square are used when mounting flat or low-slope roof constructions. Mounting triangles are left or right sided. Left sided triangles are used on the edge of the entire structure of the panels. This type is suitable for mounting panels in a vertical orientation.
The triangles are made of aluminum on an L-type angle bracket base. The use of right and left sided triangles/Set square is very important, especially if you decide to go into the installation of a load construction. For this type of solution, L-type profiles are additionally used between the right and left sided triangles, which are then pressed with weights.Our triangles can be cut so that you can set a slightly different angle to the sun. However, most often most of the surface of the country is located at an angle of 15 degrees.
Reference: W.H_FW-KDP-V15ST.01
Vertical aluminum mounting triangle with an angle of 15° for mounting solar panels on flat or low-slope roofs. Angle: 40x40 mm Angle thickness: 3 mm
Reference: M.H_NAKR PROF M8
<p>T-Slot Nut with M8 ball studs - full name "T-Slot Nut with M8 ball studs". This is a small but very important element that helps in the construction of the structure and installation of solar panels. Thanks to the use of a ball on one end of the gully, it can be set in the desired place without fear of displacement during tightening. A substitute...
Reference: W.H_PROF MONT 40x45 KAB 43
Polish production Profile with an increased wall thickness of 1.3 mm It facilitates quick and efficient installation Height: 40 mm Width: 40 mm
Reference: M.H_SRUB MŁ M10X20
These screws can be used to connect profiles as well as to assemble panels with end and middle clamps. Material: stainless steel Height [mm]: 35 Diameter [mm]: 10 Thread length [mm]: 20 Head dimensions [mm]: 10x23x5
Reference: W.H_FW-KDP-V15ST.01
Vertical aluminum mounting triangle with an angle of 15° for mounting solar panels on flat or low-slope roofs. Angle: 40x40 mm Angle thickness: 3 mm
Vertical aluminum mounting triangle with an angle of 15° for mounting solar panels on flat or low-slope roofs.
2022-12-21
Dobrze się montuje
Pomysłowa rzecz. przygotowane na prawą i lewą stronę nie trzeba na dachu skręcać